926M, 930M, and 938M Small Wheel Loader Engine Air Filter Primary Element - Clean/Replace Caterpillar


Engine Air Filter Primary Element - Clean/Replace
`
926M, 930M, and 938M Small Wheel Loader [M0102414]
AIR INLET AND EXHAUST SYSTEM
AIR CLEANER GP

The primary air filter element is located in the engine compartment.


NOTICE

Never service the air cleaner when the engine is running, to avoid engine damage.



NOTICE

AVSpare recommends certified air filter cleaning services that are available at Cat dealers. The Cat cleaning process uses proven procedures to assure consistent quality and sufficient filter life.

Observe the following guidelines if you attempt to clean the filter element:

Do not tap or strike the filter element in order to remove dust.

Do not wash the filter element.

Use low pressure compressed air in order to remove the dust from the filter element. Air pressure must not exceed 207 kPa (30 psi). Direct the air flow up the pleats and down the pleats from the inside of the filter element. Take extreme care in order to avoid damage to the pleats.

Do not use air filters with damaged pleats, gaskets, or seals. Dirt entering the engine will cause damage to engine components.


Service the air cleaner filter element when the indicator light comes on. Refer to Operation and Maintenance Manual, "Alert Indicators" for information about the alert indicator.



    Illustration 1g00101864

  1. Remove the air cleaner housing cover (1).

  2. Remove the primary filter element (2) from the air cleaner housing.

    When you use pressure air, the maximum air pressure is 207 kPa (30 psi).

    1. When you clean the inside pleats and the outside pleats, direct the air along the pleats.

    2. Inspect the filter elements after you clean the filter elements. Do not use a filter if the pleats, the gaskets, or the seals are damaged.

      Note: Replace the primary element after the primary element has been cleaned 3 times. Also replace the primary element if the primary element has been in service for 1 year.

  3. Install a clean filter element and install the cover.

Information System:

Procedure to Install <NOBR>602-6792</NOBR> Work Tool Control and Wiring Kit on Certain Wheel Loaders {1408}
D7 Track-Type Tractor Electrohydraulic Systems Solenoid Valve (Switch Controlled) - Test
Cat Command for Drilling, Operator Mission Assist (OMA), Remote Operator Station (ROS), Semi- Autonomous Drill System (S-ADS) Primary Display - Operator Mission Assist (OMA)
Cat Command for Drilling, Operator Mission Assist (OMA), Remote Operator Station (ROS), Semi- Autonomous Drill System (S-ADS) System Components - Semi- Autonomous Drill System (S-ADS)
Cat Command for Drilling, Operator Mission Assist (OMA), Remote Operator Station (ROS), Semi- Autonomous Drill System (S-ADS) System Components - Remote Operator Station (ROS)
Monitor Software Group May Fail on Certain Motor Graders and Track-Type Tractors {7620}
Cat Command for Drilling, Operator Mission Assist (OMA), Remote Operator Station (ROS), Semi- Autonomous Drill System (S-ADS) Before Operation - Semi- Autonomous Drill System
Cat Command for Drilling, Operator Mission Assist (OMA), Remote Operator Station (ROS), Semi- Autonomous Drill System (S-ADS) Before Operation - Remote Operator Station
D7 Track-Type Tractor Electrohydraulic Systems Sensor Signal (PWM) - Test
Field Rework Instructions for Cab Removal Winch on All-Terrain Forklift (ATFL) {1408, 730L}
C7.1 Engines Accessory Drive - Remove and Install - Accessory Drive SAE "A" - Type 2
953 and 963 Track-Type Loader Systems Flood Lamp
Procedure to Disassemble Broken Track Tensioner on Certain 973D, and 973K Track-Type Loaders {4157, 4158, 4159}
D7 Track-Type Tractor Electrohydraulic Systems Sensor (Data Link Type) - Test
DEF Level Gauge Will Not Read Above 3/4 Full on Certain Telehandlers {7451}
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pan
953 and 963 Track-Type Loader Systems Front Idler and Recoil Spring
D7 Track-Type Tractor Electrohydraulic Systems Solenoid Return - Test
Procedure to Install the New Machine Software Group on Certain Telehandlers {7610, 7620}
953 and 963 Track-Type Loader Systems Piston Motor (Hydrostatic)
953 and 963 Track-Type Loader Systems Bank Valve
D7 Track-Type Tractor Electrohydraulic Systems Speed Sensor - Test
953 and 963 Track-Type Loader Systems Tilt Cylinder
953 and 963 Track-Type Loader Systems Track Roller (Double Flange)