950M and 962M Wheel Loaders Fuel System Secondary Filter - Replace Caterpillar


Fuel System Secondary Filter - Replace
`


    Illustration 1g06330417

  1. Fully open the engine hood. Secondary fuel filters are on the right side of the machine.

  2. Open or remove right side engine panel.

  3. Remove the fuel filters. Dispose of the used filters properly.

  4. Clean the filter mounting base with a clean, nonflammable solvent. Ensure that the O-ring sealing surface is free of debris.

  5. Lubricate the seal of the new fuel filters with clean diesel fuel. Install the new fuel filters hand tight until the seal of the fuel filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base.

    Note: There are rotation index marks on the fuel filter that are spaced 90 degrees or 1/4 of a turn away from each other. When you tighten the fuel filter, use the rotation index marks as a guide.

  6. Tighten the filter according to the instructions that are printed on the filter. Use the index marks as a guide. For non-AVSpare filters, use the instructions that are provided with the filter.

    Note: Use a Cat strap wrench to turn the filter. Ensure that the installation tool does not damage the filter.


    NOTICE

    Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.


  7. Prime the fuel system.

    Reference: Refer to Operation and Maintenance Manual, "Fuel System - Prime" for the correct procedure.

  8. Reinstall the right side engine panel, and fully close the engine hood.

Information System:

D4, D6K2 and D6K Track-Type Tractor Systems Winch Operation
D7E Track-Type Tractor Systems Electronic Control (Hydraulic System)
Supplemental Service Information for the U.S. Navy 980H Rough Terrain Forklift {0374, 6405, 6700, 7000}
950M Z and 962M Z Wheel Loaders Engine Oil and Filter - Change
525D, 535D, 545D, 555D Wheel Skidder Engine Starting with Jump Start Cables
Installation Procedure of <NOBR>469-0108</NOBR> Kit Utility Mounting Brackets Inside the Cab of Certain Medium Wheel Loaders {7301}
2014/09/04 Cat Reman Announces New Fuel Pump, Fuel Ratio Control, and Fuel Injector Options for Certain Machine Engines {1251, 1278}
2014/09/05 Cat Reman Announces New Fuel Pump, Fuel Ratio Control, and Fuel Injector Options for Certain Engines {1251, 1278}
2014/09/05 Cat Reman Has Added Valve Actuators, Valve Lifters, Rocker Arms, and Camshafts for Certain Machine Engines {1121, 1130, 1209, 1210}
525D, 535D, 545D and 555D Wheel Skidders C7.1 Engine Supplement System Pressure - Release
2014/09/05 Water In Fuel Sensor Wiring on Certain C3.4B Engines {1408, 7422}
Procedure to Install LED Lights on AD30 Underground Articulated Trucks{1429, 1434}
631K and 637K Wheel Tractor-Scraper Systems Hydraulic Cylinder Cycle Time - Check
525D, 535D, 545D, 555D Wheel Skidder Capacities (Refill)
Procedure to Install LED Lights on AD55, AD55B, and AD60 Underground Articulated Trucks{1429, 1434}
950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Ride Control Accumulator
2015/01/08 New Hose Clamps Are Now Available On Certain 950K and 962K Wheel Loaders {1380, 1380}
C3.4B Engines DEF Pump - Test
2014/09/18 The Weld For the Handrail Support Plate Assembly Has Been Improved on Certain Wheel Tractor-Scrapers {6201}
2014/09/04 New Recommendation for Use of Composite Fans {1205, 1356, 1357, 1359, 1360}
2014/10/09 Improved Cover Assembly for the Tractor Engine Oil/Fuel Filter Service Center Is Now Used on Certain 621K, 623K, and 627K Wheel Tractor-Scrapers {1806, 7261}
525D, 535D, 545D, 555D Wheel Skidder Parking Brake - Check
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Engine Supplement Engine Oil Pan - Remove and Install - Engine in Chassis
Repair of Track Loader Lift Arms And Levers {6107}