814 WHEEL TRACTOR Starting The Engine Caterpillar

1. Be sure safety link is in carry position.

2. Place transmission control in NEUTRAL.

3. Pull up on transmission safety lock.

4. Pull up on emergency and parking brake button.

5. Move hydraulic controls to HOLD.

6. Turn disconnect switch ON.

Never turn disconnect switch to OFF with engine running.

Above 60°F (16°C)

7. Depress accelerator just past detent.

8. Push in and turn HEAT-START switch to START. Release switch when engine starts.

Below 60°F (16°C)

7. Depress accelerator just past detent. Push in and turn switch to HEAT for indicated time.

8. Push in and turn switch to START. ¹Release switch when engine starts.

When Starting Fluid is Required

7. Depress accelerator just past detent.

8. Push in and turn switch to HEAT for indicated time.

9. Push in and turn switch to START, and spray starting fluid sparingly into precleaner while cranking.

10. When engine starts, it may be necessary to return switch to HEAT until engine runs smoothly. Release switch.

Starting with Boost

When using jumper cables, be sure to connect in parallel: Negative (-) to negative (-) and positive (+) to positive (+).