980 WHEEL LOADER Every 10 Service Hours Caterpillar


Every 10 Service Hours
`
1.1. (1)Steering Cylinders
2.1. (2)Bucket Control Cylinders and Linkage
3.1. (3)Lift Arms And Cylinders
4.1. (4)Bucket Positioner
5.1. (5)Frame Upper Pivot
6.1. (6)Lumber Fork Clamp
7.1. (7)Ripper
8.1. (8)Radiator
9.1. (9)Precleaner
10.1. (10)Bucket Positioner Tube
11.1. (11)Hydraulic System
12.1. (12)Engine Crankcase
13.1. (13)Transmission

(1)Steering Cylinders

Lubricate 4 fittings.

(2)Bucket Control Cylinders and Linkage

Lubricate 20 fittings.

(3)Lift Arms And Cylinders

Lubricate 10 fittings.

(4)Bucket Positioner

Lubricate 2 fittings.

(5)Frame Upper Pivot

Lubricate 1 fitting.

(6)Lumber Fork Clamp

Lubricate 6 fittings.

(7)Ripper

Lubricate 4 fittings.

(8)Radiator

Maintain coolant level to bottom of fill pipe. Use clean water that is low in scale forming minerals, not softened water.

(9)Precleaner

Check for accumulation of dirt. Empty precleaner when dirt reaches line on body.

(10)Bucket Positioner Tube

Fill oil cup.

(11)Hydraulic System

Check oil level with engine stopped and bucket lowered. Oil must be visible in sight gauge.

(12)Engine Crankcase

Check oil level with engine running at low idle, oil warm and transmission in NEUTRAL. Maintain oil level between FULL and ADD marks on ENGINE RUNNING side of gauge.

(13)Transmission

Check oil level with engine running at low idle, and transmission in NEUTRAL. Maintain oil level at FULL mark on gauge.