Always start tractor engine first.
- 1. Move transmission control to NEUTRAL.
- 2. Turn to engage transmission safety lock.
- 3. Push brake control to PARK, if so equipped.
- 4. Push cushion hitch and bail levers to LOCK-DOWN or BAIL DOWN. Be sure hitch and bail areas are clear before moving controls.
- 5. Move scraper controls to HOLD.
- 6. Turn disconnect switch ON.
Above 60°F (16°C)
- 7. Depress accelerator just past detent.
- 8. Turn switch to START. Release when engine starts.
Below 60°F (16°C)
- 7. Depress accelerator just past detent and turn switch to HEAT for indicated time (see chart).
- 8. Turn switch to START. Release switch when engine starts. It may be necessary to return switch to HEAT until engine runs smoothly.
When Starting Fluid is Required
- 7. Depress tractor accelerator just past detent.
- 8. Turn switch to HEAT for indicated time.
| NOTICE |
|---|
Never operate electric starter for more than 30 seconds without allowing 2 minutes cooling before using again. |
- 9. Turn switch to START. Disharge capsule or spray starting fluid sparingly into precleaner while cranking.
- 10. When engine starts, it may be necessary to return switch to HEAT until engine runs smoothly. Release switch.
Starting With Boost
When using jumper cables, be sure to connect in parallel: Negative (-) to negative (-) and positive (+) to positive (+).
 |
Use starting fluid sparingly. Follow manufacturers instructions carefully. Never switch to HEAT when engine is warm and running. |
 |
Starting Scraper Engine From Scraper
Ejector must be to the rear of the bowl.
Above 60°F (16°C)
- 9. Depress tractor and scraper accelerators to 1/2 engine speed.
- 10. Push to engage accelerator lock.
- 11. Push governor control out of shut-off position.
- 12. Switch to START. When engine starts, switch to OFF.
Below 60°F (16°C)
- 9. Depress tractor and scraper accelerators to 1/2 engine speed and push to engage accelerator lock.
- 10. Push governor control out of shut-off position, turn HEAT-START switch to HEAT for indicated time. (See chart on page 21.)
- 11. Switch to START. When engine starts, switch to OFF. It may be necessary to return switch to HEAT until engine runs smoothly.
| NOTICE |
|---|
Use starting fluid sparingly. Follow manufacturers instructions carefully. Never switch to HEAT when engine is warm and running. |
Starting Scraper Engine From Tractor
Start scraper engine from tractor only after engine has been stop ped for a short period of time.
- 9. Depress tractor and scraper accelerator pedals to 1/2engine speed.
- 10. Turn scraper HEAT-START switch to START. Release switch when engine starts.
|
Never turn disconnect switch OFF when engine is running. Damage to the electrical system could result. |
|