D11T Track-Type Tractor Power Train System Oil Sample - Obtain Caterpillar


Power Train System Oil Sample - Obtain
`
D11T Track-Type Tractor [SEBU8135]
POWER TRAIN
D11T Track-Type Tractor Power Train System Oil Sample - Obtain

------ WARNING! ------

Hot oil and components can cause personal injury.

Do not allow hot oil or components to contact skin.



NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.

Dispose of all fluids according to local regulations and mandates.


Obtain the sample of the transmission oil as close as possible to the recommended sampling interval. The recommended sampling interval is every 500 service hours. In order to receive the full effect of S·O·S oil analysis, you must establish a consistent trend of data.



    Illustration 1g01307717

  1. The oil sampling valve is located at the rear of the machine beneath the fuel tank. Remove the protective cap.


    Illustration 2g01178670

    Note: Use the supplied probe and flush the fitting with oil into an approved container before obtaining oil sample.

  2. Use 169-8373 Fluid Sampling Bottle in order to obtain a sample.

  3. After you take a sample, remove the cap with the tube and the probe from the bottle. Discard the cap with the tube and the probe. Install the sealing cap that is provided with 169-8373 Fluid Sampling Bottle.

  4. Replace the protective cap.

Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the correct fluid for your machine.

Information System:

D11T Track-Type Tractor Power Train System Oil Level - Check
854K Wheel Dozer Declaration of Conformity
993K Wheel Loader Declaration of Conformity
992K Wheel Loader Declaration of Conformity
D11T Track-Type Tractor Power Train Breather - Clean
D11T Track-Type Tractor Declaration of Conformity
C4.4 Industrial Engine Starting with Jump Start Cables - Do Not Use This Procedure in Hazardous Locations that have Explosive Atmospheres
C13, C15, and C18 Tier 4 Interim Engines Electrical Power Supply - Test
C13, C15, and C18 Tier 4 Interim Engines Speed/Timing - Test
C13, C15, and C18 Tier 4 Final Engines Exhaust Manifold
Reuse and Salvage for C175 Engine Cylinder Blocks {1201}
C13, C15, and C18 Tier 4 Interim Engines ARD Combustion Supply Air Pressure Is Low
844H Wheel Dozer Declaration of Conformity
D7E Track-Type Tractor Power Train Systems Steering Does Not Function
AD30 Underground Articulated Truck Starting the Engine
C4.4 Industrial Engine Fuel Related Components in Cold Weather
D11T Track-Type Tractor Mirror - If Equipped
C13, C15, and C18 Tier 4 Interim Engines NRS Exhaust Gas Temperature Is High
D11T Track-Type Tractor Lifting and Tying Down the Machine
D7E Track-Type Tractor Hydraulic, HVAC, and Electrical Systems Fueling Nozzle Shuts Off Prematurely (Fast Fill Fuel)
D7E Track-Type Tractor Hydraulic, HVAC, and Electrical Systems Fuel Tank Underfills (Fast Fill Fuel)
D7E Track-Type Tractor Power Train Systems Backup Alarm Does Not Function
D7E Track-Type Tractor Power Train Systems Steering Hesitates
2011/05/31 Correction to Operation and Maintenance Manual , "Braking System - Test" {4250, 4251, 4267}