 | |
| Illustration 1 | g01952504 |
There are specific safety messages on this work tool. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiarized with all safety messages.
Make sure that all of the safety signs are legible. Clean the safety signs or replace the safety signs if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety sign. Loose adhesive will allow the safety sign to fall. Replace any safety sign that is damaged or missing. If a safety sign is attached to a part that is replaced, install a safety sign on the replacement part. Your AVSpare dealer can provide new safety signs.
Do Not Operate (1)
This safety message is located at the rear of the work tool near the serial number plate.
 |
| g01051172 |
 |
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any AVSpare dealer for replacement manuals. Proper care is your responsibility. |
 |
Forks (2)
This safety message is positioned on both sides of the work tool.
 |
| g01059274 |
|
Side loading of the forks may cause premature failure of the forks and thus a crush hazard which may cause personal injury or death. Never push loads with the forks and inspect the forks daily for any twisting or bending observed in the forks. Should twisting or bending be observed, change the fork(s) prior to any lifting operation. Read the Operation and Maintenance Manual for more information about the correct use of the forks. |
|
Crushing Hazard (3)
This safety message is positioned on both sides of the work tool.
 |
| g00943172 |
|
No clearance for person in this area during operation. Severe injury or death from crushing could occur. Stay away from the work tool while it is in operation. |
|