650 & 660 TRACTOR-SCRAPERS Moving The Tractor-Scraper Caterpillar

Moving The Tractor-Scraper
1.1. Emergency and Parking Brake Systems
2.1. Emergency Stops
3.1. Changing Gear Speed and Direction
1. Fasten seat belt.

2. Push emergency brake button. Do not move machine until low air pressure light goes off and brake button remains depressed.

If equipped with Emergency and Parking Brake System, move lever to EMERGENCY position for at least 3 seconds before moving lever to RELEASE. (See page 22 for additional information.)

3. Depress brake pedal.

4. Pull lever to raise bowl.


Do not move machine without normal air pressure. Check to see if area is clear of personnel and obstructions.

5. Push and turn transmission safety lock to OFF. Pull transmission control lever to desired speed.

6. Release brake pedal. Depress accelerator pedal.

Emergency and Parking Brake Systems

1. If parking brake does not release, move lever to EMERGENCY position. Push governor override button to raise air pressure to 150 PSI.

2. Release override button and move lever to RELEASE.

Emergency Stops

If low air pressure warning light comes on, or emergency warning horn sounds, stop the machine immediately.

To stop machine if the service brakes do not; push emergency brake lever to EMERGENCY position or pull emergency button.

------ WARNING! ------

Brakes will automatically apply if air pressure drops below safe operating pressure.

If the machine is stopped on a steep grade by the emergency system, do not release brakes.

After an emergency stop, wait until air pressure gauge registers NORMAL before moving the machine. If air pressure gauge will not register NORMAL, have the air system checked.


Changing Gear Speed and Direction

Machine must be stopped and engine at low idle before pushing transmission control into REVERSE. Move transmission control with a single, quick motion.

First, second and reverse speeds are converter drive and are selected manually.

Select highest usable speed. Transmission will shift automatically between 2nd and the selected speed.

Never downshift with engine speed above 1800 RPM. Downshift only one speed at a time.

Depress transmission HOLD pedal to keep transmission from upshifting or downshifting. Transmission HOLD may be used when entering a curve or approaching a grade.

------ WARNING! ------

Improper downshifting can cause sudden reduction in travel speed. Use hydraulic retarder and/or service brakes to reduce speed before entering sharp turns, fill areas and downgrades.

Do not move transmission control with transmission HOLD applied.

Never coast downgrade. Keep transmission engaged.