Engine Oil Level - Check
`
C4.4 (Mech) Industrial Engine
[SEBU8327]
LUBRICATION SYSTEM
GAUGE GP-OIL LEVEL (DIPSTICK)
C4.4 (Mech) Industrial Engine
Engine Oil Level - Check
Show/hide table
 |
|
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. |
Show/hide table
| |
| Illustration 1 | g01165836 |
|
(Y) "Min" mark. (X) "Max" mark. | |
Show/hide table
| NOTICE |
|---|
|
Perform this maintenance with the engine stopped. |
Note: Ensure that the engine is either level or that the engine is in the normal operating position in order to obtain a true level indication.
Note: After the engine has been switched OFF, wait for ten minutes in order to allow the engine oil to drain to the oil pan before checking the oil level.
- Maintain the oil level between the "MIN" mark (Y) and the "MAX" mark (X) on the engine oil dipstick. Do not fill the crankcase above the "MAX" mark (X).
Show/hide table
NOTICE Operating your engine when the oil level is above the "FULL" mark could cause your crankshaft to dip into the oil. The air bubbles created from the crankshaft dipping into the oil reduces the oil's lubricating characteristics and could result in the loss of power.
- Remove the oil filler cap and add oil, if necessary. Clean the oil filler cap. Install the oil filler cap.
Information System:
C4.4 (Mech) Industrial Engine
Product Lifting
938G II Wheel Loader and IT38G II Integrated Toolcarrier
Plate Locations and Film Locations
2007/03/19
Improved Rear Brake Oil Cooler Lines Now Used {1380}
611 Wheel Tractor-Scraper
Maintenance Interval Schedule
953D, 963D and 973D Track-Type Loaders Monitoring System
Data Link
Payload Control System (PCS) 2.X
Calibration
Payload Control System (PCS) 2.X
Sensors
C9.3 Engines for Caterpillar Built Machines
Water Pump - Assemble
D6K Track-Type Tractor Hydraulic System
Calibration
D3K, D4K and D5K Track-Type Tractors Winch Systems
Piston Pump
D3K, D4K and D5K Track-Type Tractors Machine Systems
Pump Drive Coupling - Remove and Install
Inspection and Thermal Spray Procedure of Differential Case and Components for Certain Models {0679, 3258, 3284}
C4.4 (Mech) Industrial Engine
Engine Description
C4.4 and C6.6 Engines for Caterpillar Built Machines
E360 Low Engine Oil Pressure
C4.4 (Mech) Industrial Engine
Overhaul Considerations
C4.4 (Mech) Industrial Engine
Radiator - Clean
C4.4 and C6.6 Engines for Caterpillar Built Machines
E361 High Engine Coolant Temperature
C4.4 and C6.6 Engines for Caterpillar Built Machines
E539 High Intake Manifold Air Temperature
C4.4 (Mech) Industrial Engine
Engine Air Cleaner Element (Dual Element) - Clean/Replace
2007/04/23
Improved Lines for the Aftercooler are Used {1380}
993K Wheel Loader Steering System
Piston Pump (Steering)
D3K, D4K and D5K Track-Type Tractors Power Train
Track Drive Motor - Disassemble
D3K, D4K and D5K Track-Type Tractors Power Train
Track Drive Motor - Assemble
IT38H Integrated Toolcarrier and 938H Wheel Loader Power Train
Differential Pinion (Locking) - Disassemble